Arduino Code

// © RHYS TURNER sensor (triggered) relay sketch
int LEDpin = 13;        // LED on 13 indicates running
int relayPin1 = 11;    // LED connected to digital pin 11
int relayPin2 = 12;    // LED connected to digital pin 12
int anIn1 = 0;
int anIn2 = 1;

int iAnVal1; //store sensor val 1
int iAnVal2; //store sensor val 1

int Thresh0 = 40;
int Thresh1 = 40;

void setup() {
Serial.begin(9600);          //Serial.write.
pinMode(LEDpin, OUTPUT);     // prepare the pin “LEDpin” for output
pinMode(relayPin1, OUTPUT);  // sets the digital pin as output 1
pinMode(relayPin2, OUTPUT);  // sets the digital pin as output 2
}

void loop()
{
iAnVal1 = analogRead(anIn1);   // read a value from the sensor 1
iAnVal2 = analogRead(anIn2);   // read a value from the sensor 2
delay(150);
//Serial.println(iAnVal1);
Serial.println(iAnVal2);
if (iAnVal1<Thresh0) {digitalWrite(relayPin1,HIGH);} else {digitalWrite(relayPin1,LOW);};
if (iAnVal2<Thresh1) {digitalWrite(relayPin2,HIGH);} else {digitalWrite(relayPin2,LOW);};
digitalWrite(LEDpin,HIGH);
delay(150);
digitalWrite(LEDpin,LOW);
}

Invisible Rhys 1

Invisible Mel 1